Preview
WWMG-0711-6185
ASRaymond’s SPEC® Wave Spring Washers provide a thrust load and absorb vibration in applications with very limited axial space. Stamped from flat-rolled steel sheets, these pre-engineered Wave Spring Washers are stamped complete, or wound on edge, with a small gap of overlap of the strip.
Typical applications for Wave Springs are in rotating mechanisms. They eliminate “play” (or excessive space) on bearings supporting a shaft. Wave Spring Washers also accommodate thermal expansion and contraction without introducing play in the design. Applications include pre-loading bearings to prevent slop or backlash in assemblies. Motors, gearboxes or speed-reducers, and connectors are all examples of typical devices that use Wave Spring Washers in this way. They are available in both carbon and stainless steel and are supplied with a plain finish. A common application for Overlap Wave Spring Washers is placement adjacent to smaller bearings, where shaft take-up or thermal expansion and contraction accommodation is required. They are available in stainless steel and carbon steel.
Diagram / specifications section
| FH | Free Height (in) | 0.28 |
| R | Inside Diameter (in) | 8.038 |
| P1 | Load at H1 (lbf) | 139 |
| H1 | Loaded Height (in) | 0.156 |
| OD | Outside Diameter (in) | 8.858 |
| t | Thickness (in) | 0.032 |
Item specifications
- MaterialHigh Carbon Steel Strip
- Material Chemistry/DimensionalJIS G3506
- Material TypeCarbon Steel
- Max. Operating Temperature (F)250
- Min. Operating Temperature (F)-40
- Weight (lb)0.099
